Driveways / Exposed aggregate / Paths / Patios / Slabs
Concreters for Glen Waverley and Monash
Driveways, exposed aggregate, paths, patios and garage slabs for the Waverley suburbs. Measured free, quoted once in writing, poured with steel in every slab and the crossover permit handled in the schedule.
- Free site measure
- Fixed written quote
- Steel in every slab
Free site measure
We come to the job, walk it with you and take the levels. No charge, no obligation to go ahead.
One written figure
The quote lands in writing after the measure and that number is the number. No day-of extras.
Rates in the open
Every per metre rate we charge is published on this site before you ever ring us.
Monash crossovers handled
Crossing permits, council clearances and inspections are priced into the quote where your job needs them.
Pick the job
Concreting we book across Monash
Concrete driveways
Replacement and new driveways for the Waverley suburbs, poured over a compacted base with steel through the slab, in the finish you pick at the measure, for one written figure.
$95-$185 per m² View concrete driveways →
Exposed aggregate concrete
Decorative stone finishes for driveways, entrances and outdoor living areas, chosen from sample boards at your place and sealed after curing, at $130-$185 per square metre.
$130-$185 per m² View exposed aggregate concrete →
Concrete paths
Front paths, side access strips and garden walkways poured at proper thickness with falls that carry water away from the house, from $90 per square metre.
$90-$130 per m² View concrete paths →
Patios and alfresco slabs
Entertaining slabs, barbecue areas and under-pergola floors poured level, drained properly and finished to match the house, from $100 per square metre.
$100-$180 per m² View patios and alfresco slabs →
Shed and garage slabs
Slabs for garden sheds, garages and workshops, poured square, level and to the thickness the building actually needs, from $110 per square metre. Outbuildings only.
$110-$150 per m² View shed and garage slabs →
Concrete removal and replacement
The old surface cut, broken, loaded and gone, then the new one built properly in its place. Removal adds $35 per square metre to whichever new surface you choose.
Adds $35 per m² to the new surface View concrete removal and replacement →The finish
Struck off level, finished to order
Concrete leaves the truck as a wet heap. The job is everything that happens next: screeded flat, worked to the finish you picked, then left alone to cure hard.
- Broom finish
- Steel trowel
- Full depth colour
- Exposed aggregate
Cost calculator
Ballpark the job in ten seconds
These are the Monash rates we are quoting right now (September 2026). Guide rates until the job is measured; the written quote after the visit is the number we hold to.
The run sheet
Booked in four moves
You get in touch
Ring or send the form with the suburb and the job. We call back, ask a couple of questions and lock in a time to look at it.
We measure it
At the block we take levels and access, talk finishes over samples, and flag any Monash crossing permit. The written figure follows and stays put.
We pour it
Break-out if needed, base compacted, steel on chairs, council pre-pour inspection where the crossover requires one, then the concrete goes down. Most homes take a day or two.
It cures, you drive
Joints cut early, foot traffic next day, cars off it for a week, and sealer on exposed stone once it has cured.
Built, not just poured
What sits under every surface
The part of the job you never see again is the part that decides how long it lasts. All four of these ride on every quote. Read the full specification.
The ground
Soft spots and old fill come out and a compacted rock base goes in where the ground calls for it. Monash clay moves with the seasons; the base is what argues back.
The steel
Mesh sits on chairs in the middle of the slab on every job, sized up where cars and vans will stand. Steel on the dirt does nothing; ours is placed to work.
The water
Falls get set before the pour so rain runs to the street or a formed drain, never back at the garage door or the house wall.
The lines
Control joints go where the slab wants to crack and where the eye wants a line, cut early, and new work is isolated from footings and old concrete.
Straight answers before you book
What do concreters charge in Glen Waverley?
Our card is public: $90-$130 per square metre for paths, $95-$185 for driveways depending on the finish, $100-$180 for patios and alfresco slabs, $110-$150 for shed and garage slabs and $130-$185 for exposed aggregate, with $35 per m² added when an old surface has to come out. Guide rates until the job is measured; the written quote after the visit is the number we hold to.
Do I need a council permit for my driveway?
For the driveway inside your boundary, no. For the crossover, the section joining your block to the road, yes: the City of Monash requires a vehicle crossing permit before that section is built or rebuilt, inspects the formed-up crossing before the pour, and limits residential properties to one crossing at up to 3.5 metres wide. We identify what your job needs at the measure and put the permit path in the quote.
How quickly can you look at my job?
For the Waverley suburbs, usually inside a few days of your call, and the rest of Monash the same week. The written quote follows the measure promptly, and pour dates are booked as soon as you accept. Small jobs slot between big ones, so a path or shed base rarely waits long.
Whole frontage or one path, what size job do you take?
Both ends. A knockdown-rebuild frontage with drive, crossover, porch and paths is a normal booking, and so is a single side strip. Small jobs price best when they share a pour with something bigger, and we will tell you when waiting a week to pair jobs saves you real money.
Where we pour
Glen Waverley and the suburbs around it
We keep the trucks inside the City of Monash: 8 suburbs, one council, one crossover process we deal with every week. Short runs between jobs keep the schedule honest and the quotes sharp.